Wallbox Pulsar Plus and Power Boost: 100A Panel Guide
The Pulsar Plus comes in 40A and 48A versions with adjustable current. Power Boost can throttle charging to the supply available, which may help a 100A panel, but the hardware and settings must come from Wallbox.
⚠️ Safety first: Work inside a panel or on a 240V circuit should be done by a licensed electrician, with a permit where your area requires one. This page explains the planning, not how to do the wiring.
What the datasheet says
Wallbox's North American Pulsar Plus datasheet lists two output ratings: 40A (9.6 kW) and 48A (11.5 kW), on 208/240V. The 40A model can use a NEMA 14-50 plug or be hardwired; the 48A model is hardwired only. Current can be set with a hardware selector from 16A up to the rated current, or in software from 6A up to the rated current, with optional dynamic adjustment through an energy management system. The datasheet does not state a breaker size, so use the installation manual for your exact model.
Breaker arithmetic at 125%
Because EV charging is a continuous load, the circuit is sized at 125% of the charging current. This is arithmetic from NEC 625.41, not a Wallbox figure.
| Charging current | Power at 240V | Breaker at 125% |
|---|---|---|
| 48A | 11.5 kW | 60A |
| 40A | 9.6 kW | 50A |
| 32A | 7.7 kW | 40A |
| 24A | 5.8 kW | 30A |
| 16A | 3.8 kW | 20A |
Where Power Boost fits
Wallbox's Power Boost manual says the charger can adjust the car's charging power according to what the household is using and what remains available on the main supply. It works only with energy meters supplied by Wallbox, installed after the utility meter and before the house loads split. The manual describes a clip-on clamp meter for single-phase installations up to 100A, and the Max Current setting is entered in the Wallbox app. On the Pulsar Plus, a switch on the cover is set to "T" for the RS485 connection. That manual is an older general document, and the North American datasheet only says load management may need a power meter accessory. Confirm the exact meter, wiring and settings for your model and region in the current Wallbox installation guide before buying.
Why this matters for a 100A panel
Power Boost-style load management is meant to keep the charger within the supply it can safely draw, so it can reduce the need for a service upgrade. Whether it satisfies your inspector depends on NEC 625.42 and local rules, which treat an energy management system under 750.30. See our smart load management guide and NEC 220.87 guide. If you plan a fixed lower setting instead, 625.42(B) requires restricted access to the adjustment and a durable label showing the adjusted rating.
Plug or hardwire
A NEMA 14-50 receptacle is only appropriate for the 40A model, and the plug-in connection must suit the receptacle and circuit. If the panel is tight, a hardwired charger on a lower setting is a common compromise; see dryer outlet and splitter code.
Sources
Frequently Asked Questions
Q: What current does the Wallbox Pulsar Plus offer in North America?
A: The datasheet lists 40A (9.6 kW) and 48A (11.5 kW) models. The 40A can use a NEMA 14-50 plug or be hardwired; the 48A is hardwired only.
Q: Can the charging current be lowered?
A: Yes. The datasheet lists a hardware selector from 16A to the rated current and software setting from 6A to the rated current.
Q: Does Power Boost work with any meter?
A: Wallbox's manual says only energy meters supplied by Wallbox are compatible. Confirm the right meter for your model in the current installation guide.