SCE 200A Panel Upgrade: Steps and What to Ask
In Southern California Edison territory the panel and wiring at your home are your responsibility, while the utility controls its own equipment. Here is the usual shape of the job.
⚠️ Safety first: Work inside a panel or on a 240V circuit should be done by a licensed electrician, with a permit where your area requires one. This page explains the planning, not how to do the wiring.
Customer side and utility side
A panel upgrade normally involves a licensed electrician replacing the panel and, if needed, the meter socket and service conductors, under a permit from your city or county and with an inspection. The utility owns its service equipment and meter. When the upgrade changes the service size or the utility's equipment, contact SCE for its current requirements and process. We have not verified SCE's current forms or timelines here, so confirm with SCE directly.
Costs and timing
Costs vary widely by home, location and scope, and utility rules change, so this page does not quote a price. Get written quotes from licensed electricians, ask your utility for its current requirements, and see our national panel upgrade cost guide for typical ranges. Ask your electrician whether the job includes the permit, the meter socket and any trenching or conduit work, since these are common reasons quotes differ.
Ways to avoid an upgrade
If the goal is an EV charger or heat pump, a lower charger current, load management or a measured-demand calculation may avoid a service upgrade; see our smart load management guide and NEC 220.87 guide.
Sources
Frequently Asked Questions
Q: Does SCE upgrade my panel?
A: The panel is customer equipment installed by a licensed electrician. SCE controls its own meter and service equipment. Confirm current requirements with SCE.
Q: How much does a 200A upgrade cost in Southern California?
A: This page gives no figure. Costs vary by home and scope; get written quotes and see our national cost guide.
Q: Can I avoid a service upgrade for an EV charger?
A: Sometimes. Lower charger settings, load management or measured demand may help; your inspector decides what is accepted.